Zanussi ZVF 200 RM Talimat Kitapçığı - Sayfa 7

Dondurucu Zanussi ZVF 200 RM için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZVF 200 RM 13 sayfaları.

Door reversibility

Unplug the freezer before performing the following

operations:

Remove the ventilation grill (D).

Remove the lower hinge (E) by loosening the two

fastening screws.

Remove the door by sliding it out of the upper pin (A-

Fig. 3).

Unscrew the pin and the washer (A+B-Fig. 3) and

reﬁt them on the opposite side.

Reﬁt the door.

Reﬁt the lower hinge (E-Fig. 2) on the opposite side

by means of the two screws that have been previously

removed.

Remove the plug (F) from the ventilation grill (D) and

replace it on the opposite side.

Reﬁt the ventilation grill.

Remove the handle and reﬁt it on the opposite side

(Fig. 4).

Unscrew the handle. Reﬁt it on the opposite side after

having pierced the plugs with a punch. Cover the

holes left open with the plugs contained in the

documentation pack.

If, after having reversed the door, it is not in line with

the unit, the top hinge can be adjusted.

To do this, use a 10 mm spanner as shown in Figure 3;

slacken the nut, align the door by pushing it to the left

or right, then re-tighten the nut.

Attention

After having reversed the opening direction of the

door check that all the screws are properly

tightened and that the magnetic seal adheres to the

cabinet. If the ambient temperature is cold (i.e. in

Winter), the gasket may not ﬁt perfectly to the

cabinet. In that case, wait for the natural ﬁtting of the

gasket or accelerate this process by heating up the

part involved with a normal hairdrier.

D640

D427

D162

Fig. 2

Fig. 3

Fig. 4