Zanussi ZHC 913 Talimat Kitapçığı - Sayfa 12
Havalandırma Davlumbazı Zanussi ZHC 913 için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZHC 913 21 sayfaları. Cooker hood
Ayrıca Zanussi ZHC 913 için: Talimat Kitapçığı (20 sayfalar)
Sayfayı Yazdır
Clearance Height
The cooker hood is designed to be fitted over a
cooking appliance at the clearance heights stated,
providing the maximum output of the appliance
beneath does not exceed the maximums quoted in
the Technical Specifications.
If the output of the appliance below the cooker
hood exceeds the maximum outputs quoted,
please refer to the cooker manufacturer's
installation instructions.
A clearance height of 650mm (25 1/2 ") is required
when installed above a built-in electric hob, or 700mm
(27 1/2 ") when installed above a built-in gas hob.
A clearance height of 685mm (27") is required when
installed above a slot-in electric cooker, or 787mm (30
1/2 ") when installed above a slot-in gas cooker.
When installed between adjoining wall
cabinets, the wall cabinets must not overhang
the hob and the distance between the
underside of the cabinet and the worktop must
be 450mm. If the height of the wall cabinet is
less than 450mm, a gap of 50mm must be
maintained either side of the hob.
This cooker hood must not be installed above
a cooking appliance with a high level grill.
Fitting the Wall Brackets
1.
Draw a vertical line on the wall from the
centre of the cooking appliance up to the
ceiling, using a spirit level and marking pen.
This is to ensure the correct vertical
alignment of the appliance.
2.
Drow a horizontal line trough the vertical at
190mm .Mark the centre positions for the
bracket fixing screw(4) at 107mm either side
of the vertical line.(screw not supplied)
Ensure that the distance between the
lowest point of the hood and the cooking
appliance beneath meet the clearance
requirements quoted above.
3
Draw a horizontal line through the vertical
at 270mm. Mark the centre positions for
the lower bracket fixing screws (1) at
110mm either side of the vertical line (screws
not supplied).
4.
Draw a horizontal line through the vertical
at 45mm from the ceiling or from the
maximum height of the chimney. Mark the
centre positions for the upper bracket
fixing screws (2) at 80mm either of the
vertical line (screws not supplied).
A: Built-in Electric Hob:
B: Built-in Gas hob:
C: Slot-in Electric Cooker: 685mm clearance
D: Slot-in Gas Cooker:
12
Hob
650mm clearance
700mm clearance
787mm clearance