Zanussi ZHC 927 Kurulum, Kullanım ve Bakım El Kitabı - Sayfa 6

Havalandırma Davlumbazı Zanussi ZHC 927 için çevrimiçi göz atın veya pdf Kurulum, Kullanım ve Bakım El Kitabı indirin. Zanussi ZHC 927 13 sayfaları.

The Rear Panel comprises a bottom panel and a top profile connecting to the Hood.

The Rear Panel must be fitted before fixing the hood body and, for both upper and lower position fixing,

must be fitted at the correct height prior to installing the bases. As this operation is rather complex, it

should be carried out either by the kitchen installer or a qualified person who knows the final dimensions

of the units.

For the upper fixing position, proceed as follows:

• Rest the back panel on the base, inserting the lower plate between

the upper surface and the wall, centring it on the vertical reference

line.

• Mark the centres of the two holes in the upper plate.

• Drill ø 8 mm holes at all the centre points marked.

• Insert the wall plugs 11 in the holes.

• Position the top Profile 20 so that it rests against the top edge of the

Back panel, making sure that the screw holes coincide.

• Fix the Back panel to the Profile, using the screws 12a provided.

• Close the holes using the plugs 13 provided.

• Before attaching the hood body, tighten the two

screws Vr located on the hood body mounting

points.

• Hook the hood body onto the screws 12a.

• Fully tighten support screws 12a.

• Adjust screws Vr to level the hood body.

REAR PANEL (OPTIONAL)

Mounting the hood body