Zanussi ZC 605 M Manuel - Sayfa 17

Ocaklar Zanussi ZC 605 M için çevrimiçi göz atın veya pdf Manuel indirin. Zanussi ZC 605 M 18 sayfaları. Electrogas cooker

ELECTRICAL CONNECTION

The unit is preset to work with a voltage of single phase

230 V.

Before making the connection make sure that:

— the energy power available in the user's house is

sufficient for the normal supply of this appliance

(see rating plate).

— the unit is correctly connected to earth through a

suitable plug and according to the installation

country Laws.

— the socket or the omnipolar switch used for the

connection must be easilv reached with the installed

appliance.

The appliance is supplied without electric cord:

consequently, you have to install a plug fit for the load

shown in the serial number plate. The plug has to be

connected to an adequate socket.

If you wish to directly connect to the mains, you have

to interpose an omnipolar switch with a minimum

opening between contacts of 3 mm, between the unit

and the mains, complying with the existing regulations.

The brown live wire (originating from the clamp of the

cooker junction box) must always be connected to the

phase of the mains supply. In any case, the supply cord

must be positioned in such a way as it doesn't reach in

any point a temperature higher by 50 C than the room

temperature.

Should the supply cord need to be replaced, use only

type H05RR-F cables. It is necessary that the yellow/

green earth wire is about 2cm longer than the live and

neutral ones (Fig. 17).

After the connection, test the heating elements for

about 3 minutes to ensure that they are working

correctly.

The manufacturer refuses any responsability in

cases where normal safety measures are not

observed.

Phase

Ground (yellow - green)

FO 0480

Neutral

wire

Fig. 17