Zanussi ZCG92696XA Kullanıcı Kılavuzu - Sayfa 8

Ocaklar Zanussi ZCG92696XA için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZCG92696XA 33 sayfaları.

Sayfayı Yazdır

Clean the oven and the accessories before the first

use.

Put the accessories and the removable shelf

supports back to their initial position.

SETTING THE TIME

You must set the time before you operate the oven.

The

flashes when you connect the appliance to

the electrical supply, when there was a power cut

or when the timer is not set.

Press the

to set the correct time.

After approximately five seconds, the flashing stops

and the display shows the time of day you set.

CHANGING THE TIME

You cannot change the time of day if

the Duration

operates.

HOB - DAILY USE

WARNING! Refer to Safety chapters.

IGNITION OF THE HOB BURNER

Always light the burner before you put

on the cookware.

WARNING! Be very careful when you

use open fire in the kitchen

environment. The manufacturer

declines any responsibility in case of

the flame misuse.

The spark generator can start

automatically when you switch on the

mains, after installation or a power cut.

It is normal.

In the absence of electricity you can

ignite the burner manually.

Ignition of a hob burner with the

thermocouple

•

For manual ignition put the flame near the

burner. Push the knob for the hob down and

turn it counterclockwise to the maximum gas

flow position

or End

function

Press

again and again until the indicator for the

Time of Day function flashes.

To set a new time, refer to "Setting the time".

PREHEATING

Preheat the empty appliance to burn off the

remaining grease.

1. Set the maximum temperature.

2. Let the appliance operate for approximately 1

hour.

WARNING! Accessories can become

hotter than usual.

The appliance can emit an odour and smoke. This is

normal. Make sure that the airflow is sufficient.

Let the oven cool down. Dampen a soft cloth with

warm water and a little mild washing-up liquid and

use this to clean the oven cavity.

•

For integrated ignition on knob push the knob

for the hob down and turn it counterclockwise

to the maximum gas flow position

Keep the knob for the hob pushed for equal or less

than 10 seconds to let the thermocouple warm up.

If not, the gas supply is interrupted.

Adjust the flame after it is regular.

WARNING! Do not keep the knob

pushed for more than 15 seconds. If

the burner does not light after 15

seconds, release the knob, turn it into

the off position and try to light the

burner again after minimum 1 minute.

If after some tries the burner does not

light, check if the crown and its cap

are in the correct position.

If the burner accidentally goes out,

turn the knob to the off position and try

to light the burner again after minimum

1 minute.