Zanussi ZCM 700 Talimat Kitapçığı - Sayfa 27

Ocaklar Zanussi ZCM 700 için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZCM 700 32 sayfaları.

Fitting the Stability Bracket

(Not supplied)

If the cooker has to be installed with a flexible supply

pipe, it is necessary that a stability device is fitted.

If a stability bracket should be fitted by the installer, these

instructions should be read in conjunction with the leaflet

packed with the stability bracket.

1. Place the cooker in its intended position and

mark the cooker height.

2. Mark 165mm below the cooker height. This is

the position of the stability bracket.

3. Fix a large type of stability bracket (using two

of the provided five fixing holes) to the rear wall

(see the picture below).

4. Pull the cooker towards the rear wall as shown

in the diagram. The stability bracket should

then come into contact with the rear panel of

the cooker (see diagram).

Should the stability bracket currently installed not allow

the cooker to stand correctly, ask the installer to replace

it with the correct type.