Zanussi ZYB 591 Talimat Kitapçığı - Sayfa 35
Ocaklar Zanussi ZYB 591 için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZYB 591 42 sayfaları.
![Zanussi ZYB 591 Talimat Kitapçığı](/uploads/products/server2/7128068/7128068.jpg)
Instructions for the Installer
Installation and connection must be
done in compliance with the
regulations
interventions must be carried out
when the appliance is switched off.
Only accredited engineers may work
on the appliance.
The manufacturer disclaims any
liability if the safety measures are not
observed.
Connecting to the electrical supply
Before connecting to the electrical supply, please
make sure:
-
The fuse and the domestic electrical installation
must be designed for the max. load of the
appliance (see rating plate).
-
The domestic electrical installation must be
equipped with a proper earth connection in
accordance with the regulations in force.
-
The socket or the multi-pole off switch must be
easy to access after the appliance has been
installed.
The appliance is supplied with the plug attached.
The mains cable and plug as supplied are to be
connected to a shockproof socket (230 V~, 50
Hz). The shockproof socket must be installed in
accordance with the regulations.
The following types of mains cable are suitable,
taking the necessary rated cross section into
account: H07 RN-F, H05 RN-F, H05 RR-F, H05
VV-F, H05 V2V2-F (T90), H05 BB-F.
If the appliance is connected without a plug, or if
the plug is not accessible, a multi-pole off switch
(e.g. fuses, circuit breaker) with a minimum gap of
3 mm between the contacts must be installed
between the appliance and mains cable. The switch
must not interrupt the earth wire at any point. The
yellow-green earth wire should be 2-3 cm longer
than all other cables.
in
force.
Any
The connection cable must in any case be laid out
so that at no point does it reach 50°C (over room
temperature).
After the connection has been carried out, the
heating elements must be tested by being operated
for about 3 minutes.
Terminal block
The oven is fitted with an easily accessible terminal
block which is designed to operate with a single-
phase power supply of 230 V.
Letter L -
Live terminal
Letter N-
Neutral terminal
or E -
Earth terminal
electrolux 77
77