Alecto WS-1550 Kullanıcı Kılavuzu - Sayfa 5

Hava İstasyonu Alecto WS-1550 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Alecto WS-1550 8 sayfaları. Weather station with wireless outdoor sensor

Sayfayı Yazdır

Rain

Cloudy

Outdoor unit display:

Press CHANNEL (15) to switch the display

between the channels (CH1/2/3). Select the

channel on which the outdoor unit is set (9).

When selecting

per channel changes. This is only useful

when using multiple outdoor units.

Other:

Display lighting:

When the indoor unit is powered by the

power adaptor, the display lighting is en-

ables continuously. Press the On/Off (17)

button to enable or disable the background

lighting. When the indoor unit is powered

only by the batteries, the display lighting

only switches on by pressing the On/ Off

(17) button. To conserve battery power,

the display lighting turns off after approx.

5 seconds.

(28), the data displayed

Battery alert:

When the battery indication 'IN' (21) illumi-

nates, the batteries of the indoor unit must

be replaced. When the battery indication

'OUT' (31) illuminates, the batteries in the

outdoor unit with the concerned number

must be replaced. Additionally, the LED on

the outdoor unit starts flashing when the

battery capacity is too low.

Reception of radio time signals:

The antenna symbol

DC-77 receiver is enabled for reception.

Upon start-up, the receiver will be enabled

for 10 minutes. After that, the receiver

switches on for time synchronization each

day at 2am, 3am, 8am, 12pm, 2pm and

8pm.

You may also manually switch on the DC-77

receiver by pressing and holding the DOWN

(12) button for 3 seconds.

To register outdoor units:

Now press and hold the CHANNEL (15)

button for at least 3 seconds until the display

icon

(29) starts flashing. Set the outdoor

unit to the desired channel (9) and then

press the TX (7) button behind the battery

cover. The measured value with the chan-

nel number appears in the display of the

indoor unit. Now press and hold the CHAN-

NEL (15) button for at least 3 seconds to

confirm the input. The outdoor unit is now

registered.

Display in °C or °F:

Briefly press the C/F (14) button on the

indoor unit to display the temperature in

ºCelsius or in ºFahrenheit.

(25) shows that the