Directed Directechs DB3 Kurulum Kılavuzu - Sayfa 6

Kilitler tarafından Directed Directechs DB3 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Directed Directechs DB3 19 sayfaları. Smart key for 2013 toyota highlander
Ayrıca Directed Directechs DB3 için: Kurulum Kılavuzu (20 sayfalar), Manuel (6 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (10 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (10 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (17 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (18 sayfalar)

Sayfayı Yazdır
Directed Directechs DB3 Kurulum Kılavuzu
OEM remote starter detection
If the vehicle has an active OEM remote starter it will program into convenience only (no immobilizer bypass). The reason for this
is to allow aftermarket security to be installed while keeping the factory remote starter active. If you wish for the interface to control
the remote start sequence, perform one of the following:
How to determine if a vehicle is equipped with an OEM remote starter?
1
An "ENGINE STARTER" sticker should be on the remote.
Press the remote control's lock button twice within 2 seconds, then press and hold the lock
button for 3 seconds.
2
The parking lights flash after 3 seconds. The engine starts and the parking lights flash
repeatedly for 20 seconds.
If the vehicle is equipped with an Add-On Lexus/Toyota OEM remote starter: The factory remote starter must be
Š
permanently disconnected before programming the Directed interface as both modules cannot coexist. See "Physical OEM
remote start fuse location".
If the vehicle is equipped with a BCM Enabled Lexus/Toyota OEM remote starter: The vehicle does not have a physical
Š
remote starter and only one module can be programed at a time. In this case temporally disable the OEM remote start system
using the following process:
1. Remove the fuse powering the OEM Remote Starter. See "OEM remote start fuse location"
2. Perform a "Soft reset" or "Hard reset".
3. Perform the "Module programming".
4. After programming is successful replace the fuse powering the OEM Remote Starter.
OEM remote start fuse location
Make
Model
Lexus
ES 300h (Smart Key)
Lexus
ES 350 (Smart Key)
Lexus
GS 350 (Smart Key)
Lexus
GS 450h (Smart Key)
Physical OEM remote start fuse location
Make
Model
Toyota
Avalon (Smart Key)
Toyota
Avalon Hybrid
Toyota
Camry (Smart Key)
Toyota
Camry Hybrid
Toyota
RAV4 (Smart Key)
6
Year
2013-2015
Engine room relay box, left side of engine compartment.
2013-2015
Engine room relay box, left side of engine compartment.
2013-2016
Engine room relay box, right side of engine compartment.
2013-2015
Bottom of luggage room junction box, left rear quarter panel.
Year
2013-2016
2013-2016
2013-2016
2013-2016
2013-2015
ENGINE
STARTER
Fuse Location
Fuse Location
Behind glovebox upper right hand side.
Behind glovebox upper right hand side.
Behind glovebox upper left hand side.
Behind glovebox upper left hand side.
High above drivers kick panel.
403.TL6 2.17 2014 Toyota Avalon (Smart Key)
© 2018-02-23 Directed. All rights reserved.
ENGINE
STARTER
Press & Hold
x2
&
for 3 seconds
Fuse
Fuse
Name
Value
Mayday
5A
Mayday
5A
DCM
7.5A
DCM
7.5A