Clarke 6500403 Kullanım ve Bakım Talimatları Kılavuzu - Sayfa 10

Sander Clarke 6500403 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları Kılavuzu indirin. Clarke 6500403 15 sayfaları. Belt/disc sander

Sayfayı Yazdır
Clarke 6500403 Kullanım ve Bakım Talimatları Kılavuzu
•
It is possible to set the table to any angle up to 45 degrees, simply by slackening
the locking lever and positioning the table using a protractor or angle setter,
then retightening the locking lever.
2. Disk Table Adjustment
•
Place an engineers square on the table
and slacken the locking levers slightly.
•
Adjust the table so it is at right
angles to the Disc, using the
square, then tighten the locking levers.
•
If necessary, adjust the pointer, adjacent
to the angle indicator beneath the
table, (B Fig.4), so that it registers zero
•
Slacken the upper disc cover securing
screws (A Fig.4) using the wrench supplied, and adjust so that a gap of 2-3mm exists
between the disc and table, and the table is square. Tighten the securing screws.
•
It is possible to set the table to any angle up to 45 degrees, simply by slackening
the locking levers and positioning the table using the angle indicator, then
retightening the locking levers. If the angle is critical, a protractor or angle
setter should be used.
•
If required, slide the Quadrant into its groove in the table.
NOTE: The quadrant may be used to hold a workpiece at any desired angle
for sanding that angle with accuracy.
Operation
IMPORTANT!
Ensure that ALL components are secure, ALL correct adjustments have been
carried out, and ALL safety precautions have been observed BEFORE plugging
the machine into the mains supply, and switching ON.
1.
Attach a vacuum cleaner or other dust extraction device to the relevant
extraction port (depending upon the medium to be used), and switch it ON.
2.
Switch the machine ON by pressing the Green ON button.
3.
If using the belt, check to ensure it is tracking properly...adjust if necessary.
4.
Holding the workpiece firmly, place it on the table and gently slide it into contact
with the belt or disk. DO NOT force it, a light
force only is necessary.
IMPORTANT!
When using the sanding disk, ALWAYS use
the left half of the disk ONLY, i.e. that ,
side where the direction of rotation of the
disk is down towards the table.
10
8