Clarke American Sanders Super 7R Operatör El Kitabı - Sayfa 4
Sander Clarke American Sanders Super 7R için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Clarke American Sanders Super 7R 16 sayfaları. Dc edger
Ayrıca Clarke American Sanders Super 7R için: Operatör El Kitabı (17 sayfalar)
Sayfayı Yazdır
- 1. Table of Contents
- 2. Operator Safety Instructions
- 3. Machine Specifications
- 4. Sanding Cuts and Sandpaper
- 5. Machine Set-Up
- 6. Operating Instructions
- 7. Adjustment Procedures
- 8. Routine Maintenance
- 9. Maintenance
- 10. Parts and Service Manual - Section II Assembly Drawing
- 11. Assembly Parts List
- 12. Wiring Diagram 11/04
DANGER:
Operating partially assembled sanding equipment could result in injury to the operator or
bystander and could cause damage to the equipment or to other property.
•
Do not operate this equipment unless it it fully assembled and all guards, doors and
covers are secured.
•
Keep all fasteners tight.
•
Keep all adjustments within manufacturers specifications.
DANGER:
Moving parts on this sanding equipment can cause injury to the operator or bystanders.
•
Keep hands, feet and loose clothing away from all moving parts.
•
Do not change or adjust the abrasive while the sanding equipment is running.
•
Do not service the sanding equipment while it is running.
DANGER:
This sanding equipment requires a supply of electricity. Improper use could result in electrical
shock or fire.
•
Connect only to an electrical source matching what is shown on the equipment name-
plate.
•
Do not use this sanding equipment on an ungrounded electrical circuit. Consult an
electrician if you suspect the circuit is not properly grounded.
•
Do not use this sanding equipment with a damaged electrical cord. Inspect before each
use.
•
Avoid striking the elelctrical cord with the abrasive. Always lift the electrical cord over
the sanding equipment.
•
Do not use the electrical cord to move the sanding equipment.
•
Disconnect the electrical source before servicing this equipment.
WARNING:
Injury to the operator or bystander can occur if protective gear is not worn while sanding.
Always use eye, ear, and respiratory protection while performing any sanding operation.
WARNING:
Bodily injury could occur if power is applied to the equipment with the power switch already
in the "ON" position. Always check to assure that the power switch is in the "OFF" position
before connecting power supply.
CAUTION:
Maintenance and repairs performed by unauthorized personnel could result in damage or
injury. Maintenance and repairs performed by unauthorized personnel will void your warranty.
Servicing of this unit must always be referred to an authorized Clarke American Sanders
distributor.
CAUTION:
Use of this equipment to move other objects or to climb on could result in injury or damage.
Do not use this equipment as a step or furniture. Do not ride on this equipment.
CAUTION:
Damage could occur to the equipment if not properly kept in a dry building for storage. Store
the equipment in a dry building.
CAUTION:
Serious damage to the floor can occur if the sanding equipment is left running in one spot while
the sanding disc is in contact with the floor. To avoid damage to the floor, do not dwell while
lowering or raising the sanding disc. Always sand with a constant motion.
Page 4
Clarke
®
American Sanders Super 7R Operator's Manual