Clarke EZ-8 Çalışma ve Güvenlik

Sander Clarke EZ-8 için çevrimiçi göz atın veya pdf Çalışma ve Güvenlik indirin. Clarke EZ-8 2 sayfaları. Drum sander
Ayrıca Clarke EZ-8 için: Operatör El Kitabı (20 sayfalar)

Sayfayı Yazdır

Safety Practices:

Sanding dust is flammable!

Empty and clean dust bag

when not in use.

Always wear safety

goggles, protective

clothing, and a dust mask

while sanding.

Keep the dust bag

emptied. Dust generated

from sanding wood floors

can spontaneously ignite

or explode. Promptly

dispose of any sanding

dust in a metal container

clear of any combustibles.

Do not dispose in a fire.

Keep the work area well

ventilated.

Sanding/finishing wood

floors can create an

explosive or combustible

environment. Do not

operate this machine

around solvents, thinners,

fuels, floor finishes, or any

other flammable materials.

Keep hands, feet, and

loose clothing away from

all moving parts on the

machine.

Disconnect the power cord

before replacing the pad or

the abrasive.

Never leave the machine

unattended while it is

connected to a power

source.

www.clarkeus.com/rental

EZ-8 Drum Sander

Operation and Safety

Application: Sand hardwood floors. Level uneven wood floors.

Set-up and operation

Follow the steps listed below to complete a floor sanding project safely.

Step

Preparation:

Step

Install handle and fasten latches.

Insert control link into notch and slide collar to

pin. Raise sanding drum with control level.

Install dust tube. Tie dust bag over bell opening

of dust tube.

Connect the handle pigtail to the motor cord.

Install abrasive (expandable drum, continuous

sleeve sandpaper OR standard drum flat

notched sandpaper).

Operational Instructions:

Step

Set exposed nails with hammer and punch.

Connect machine to grounded outlet. Press

switch to start.

Allow switch to return to run (R) position.

PREVENT DAMAGE TO THE SURFACE; MACHINE

IS ALWAYS MOVING WHEN DRUM CONTACTS

FLOOR.

Slowly lower drum to floor with control handle.

Do not force handle down to floor. Allow to

float on floor.

Operational Techniques:

Work from right to left. For each forward pass, move the

machine 4" over the pass just finished. Retrace the reverse

path without overlapping. Keep sander in motion while drum

is engaged. Move the machine in the direction of the wood

grain. Sand at a constant pace. Feather-cut termination

point of pass by easing control lever up. Stagger

termination points.