Alemite 9911-A1 Servis Kılavuzu - Sayfa 4

Su Pompası Alemite 9911-A1 için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Alemite 9911-A1 4 sayfaları. High-pressure portable pump

Sayfayı Yazdır

SER 9911-A1

Assembly

NOTE: Refer to Figure 2 for component

identification on assembly procedures.

Hand Cart Assembly

1. Remove Bolt (24), Lock Washer (25) and Handle

Assembly (26) from Fork Assembly (21)

[as shipped].

2. Position the Handle Assembly on top of the Fork

Assembly.

3. Screw the Bolt with Lock Washer into the Handle

Assembly from the bottom of the Fork Assembly.

• Tighten the Bolt securely.

Follower Plate (Not Included)

4. Loosen Thumb Screws (8) that secure Cover Assembly

(7) to Container (10).

5. Remove the Cover and Pump Assembly from the

Container.

6. Install the 35-pound container into Spacer Ring (9).

NOTE: When bulk filling Container (10),

remove the Spacer Ring and fill the Con-

tainer with product. Do not allow air to mix

with the product during the filling process.

Pump may lose prime.

Revision (5-04)

7. Place the follower plate onto the top of the product.

See Table 2.

• With a wobbling motion, eliminate any air that may

8. Guide the pump tube into the follower plate and fit the

Cover onto Container (10).

9. Secure the Cover to the Container with Thumb

Screws (8).

10. Test/Prime the Pump assembly.

• Refer to Service Guide SER 9911-1/9950-1 for

Accessories

Accessory items available for these pumps are listed in

Table 2.

Part Number

337665

338801

Table 2 High-Pressure Portable Pump Accessories

Changes Since Last Printing

Deleted Air Motor Body Check Valve

High-Pressure Portable Pump

be trapped underneath the follower plate. Force the

product through the hole in the center of the plate.

details.

Description

Follower Plate (for 35-pound container)

Follower Plate (for 70-pound container)

Alemite Corporation