Clarke HSE RANGE Kullanım ve Bakım Talimatları Kılavuzu - Sayfa 4
Su Pompası Clarke HSE RANGE için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları Kılavuzu indirin. Clarke HSE RANGE 17 sayfaları.
Sayfayı Yazdır
ELECTRICAL CONNECTIONS
WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS
THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS
SUPPLY.
Models EXCEPT HSE301A & 361A should have their mains lead connected to a
standard 230 volt (50Hz) electrical supply through an approved plug or a
suitably fused isolator switch. We recommend that these pumps be fitted with
a Residual Current Device (RCD).
NOTE: This is mandatory when pump is used for pumping swimming pools.
Models HSE301 & 361 must be connected to a protected 110V supply,
through a suitably approved connector. On no account must a 230V-13amp
plug be used.
NOTE: If a portable 110V transformer is used, make sure it has a rated
capacity sufficient to take the load of the pump.
In the event that the pump is hard-wired into the electrical system, it must be
carried out in accordance with IEE regulations.
If used for draining swimming pools or ponds, the pump MUST be fitted with a
Residual Current Device (RCD) with a rated residual operating current of no
greater than 30mA.
WARNING: THE WIRES IN THE POWER CABLE OF THIS PRODUCT ARE
COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:
BLUE = NEUTRAL
As the colours of the flexible cable of this appliance may not correspond with
the coloured markings identifying terminals in your plug proceed as follows:
• The BLUE wire must be
connected to the
terminal which is
marked N or coloured
black.
• The BROWN wire must
be connected to the
terminal which is
marked L or coloured
red.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BROWN = LIVE
YELLOW AND GREEN = EARTH
Plug must be BS1363/A approved.
Earth
(Green and
Yellow)
Neutral
(Blue)
Ensure that the outer sheath of
the cable is firmly held by the clamp
4
Always fit
a 13 Amp
fuse.
Live
(Brown)