Directed Electronics AS-1271 Kullanıcı Kılavuzu - Sayfa 8
Uzaktan Çalıştırıcı Directed Electronics AS-1271 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Directed Electronics AS-1271 12 sayfaları.
Sayfayı Yazdır
same steps as the normal Idle Mode procedure, except for when re-entering the vehicle while the
engine is running;
1.
Press the
2.
Open then close all doors.
3.
You have 1.5 minutes (or 3 minutes) to press on the brake pedal, to get in gear and
drive off.
Note 1: Pressing on the brake pedal after the allocated (1.5 or 3-min.) period will shut the engine
down.
Note 2: The engine will continue running until the user re-enters the vehicle or until the expiration
of the run time.
Note 3: If the pre-programmed run-time expires or if the user shuts down the engine remotely, the
vehicle will enter Ready Mode automatically (manual transmissions only).
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Valet Mode
When the vehicle is in Valet Mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine from being
remote-started accidentally.
Ignition Valet: This feature allows you to set Valet Mode using the ignition key.
To put the system into Valet Mode using the KEY (Ignition Valet Mode):
1.
Insert the ignition key into the ignition switch. Within 10 sec., cycle the ignition key to the
IGNITION/RUN and OFF positions 5 times until the parking lights flash 3 times.
2.
Turn the ignition OFF.
3.
The LED on the antenna will stay ON indicating that the vehicle has successfully entered
Valet mode.
To take the system out of Valet Mode using the KEY (Ignition Valet Mode):
1.
Insert the ignition key into the ignition switch. Within 10 sec., cycle the ignition key to the
IGNITION/RUN and OFF positions 5 times until the parking lights flash 2 times.
2.
Turn the ignition OFF.
3.
The LED on the antenna will switch OFF indicating that the vehicle is now out of Valet mode.
If someone attempted to remote-start the vehicle while in Valet Mode; the parking lights will turn
ON, then OFF, then will flash twice.
Cold Weather Mode
If the vehicle has a manual transmission, Ready mode (page 4) should be set before entering
Cold Weather mode. When Cold Weather Mode is active, the engine starts every 2 hours and runs
for 3 minutes (or for 8 or 20 minutes with diesel engines). Cold Weather Mode automatically ends
after 24 hours (or 12 starts).
To enter Cold Weather Mode:
•
Press and hold the
•
The parking lights will flash for 2 seconds, pause, then flash 3 times.
OR
•
If
button for at least 3 seconds until the parking lights will flash for 2 seconds, pause,
and then flash 3 times.
P.8
button to unlock. (Must be configured as LOCK/UNLOCK by installer.)
button for at least 3 seconds
was programmed as LOCK & UNLOCK by your installer, press and hold the
User Guide