Alemite 7344 Servis Kılavuzu - Sayfa 7
Araçlar Alemite 7344 için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Alemite 7344 8 sayfaları. High capacity twin hose reel
Sayfayı Yazdır
High Capacity Twin Hose Reel
CAUTION
Never connect rigid piping to the Swivel assemblies.
Damage to components can occur.
10. Attach the connecting hoses to the distribution system (with
thread sealant) and to the inlets of the reel as required.
IMPORTANT: Anchor the connecting hoses to a
suitable surface to prevent the hose from flexing
at the Swivel Assembly. The anchor should be in-
line with the inlet of the Swivel to minimize side
loading.
11. Attach the hydraulic tool to the delivery hose (with thread
sealant).
12. Pressurize the system and check for leaks.
Checking Spring Tension
Check to ensure the tension on the power spring is sufficient
to properly hold the hose stop against the Hose Guide.
Should the power spring tension require adjustment:
13. Release all pressure within the system.
WARNING
Turn off the power source.
Operate the hydraulic tool to relieve the remaining pres-
sure within the system.
14. Remove the hydraulic tool and the hose stop from the
delivery hose.
15. Unlatch the reel and allow the free end of the delivery hose
to pass through the Hose Guide.
CAUTION
Do not overwind the power spring. Too much tension
reduces the life of the spring.
16. Rotate the Sheave Assembly in the required direction.
17. Pass the free end of the hose through the Hose Guide.
18. Install the hydraulic tool and the hose stop.
19. Pressurize the system and check for leaks.
20. Check to ensure the tension on the power spring is sufficient
to properly hold the hose stop against the Hose Guide.
21. Repeat steps 13 - 20 until the proper tension is achieved.
Alemite, LLC
1-800-548-1191-http://[email protected]
Latch Lockout
Reel Over-Run
IMPORTANT: Do not extend the hose from the
reel too rapidly. Too much velocity can cause the
reel to over-run and latch.
Should latch lockout occur, pulling on the hose will not
release the latch mechanism.
With the reel latch in this condition it will be necessary to
have an assistant maintain tension on the hose while the latching
mechanism is manually released.
WARNING
The reel is under maximum spring tension.
Personal injury can occur.
1. Instruct the assistant to grip the hose securely with both
hands to prevent uncontrolled retraction.
2. Grip Sheave Assembly (18) securely with gloved hands.
3. Turn the Sheave Assembly in the direction just enough that
allows Pawl and Shaft Assembly (28) to be free of tension
from the ratchet on Power Spring Assembly (26).
• This direction further increases tension on the power
spring.
4. While maintaining the position of the Sheave assembly with
one hand, move the Pawl away from the ratchet.
• Use a screwdriver or other suitable tool.
5. Instruct the assistant to allow the hose to retract slowly onto
the Sheave Assembly.
7
SER 7343
Revision (11-08)