Directed Electronics PS-4461TWE-FM Kullanıcı Kılavuzu - Sayfa 10

Uzaktan Çalıştırıcı Directed Electronics PS-4461TWE-FM için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Directed Electronics PS-4461TWE-FM 20 sayfaları. Two-way 6-button lcd automatic/manual transmission remote starter

Sayfayı Yazdır

If your vehicle has an automatic transmission and it does not start at the first attempt, the system

will shut down, wait a few seconds and try to start the engine again. There will be 3 start attempts

before the system gives up.

Driving Off

With the vehicle running under remote control, press the

doors. Enter the vehicle and do the following:

Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK

position while the engine is running. This would cause the starter motor to re-engage.)

Press the brake pedal to disengage the remote starter unit.

You are now ready to drive off.

Arming and disarming the Starter Kill

This added security feature will prevent the vehicle from starting with the Ignition key when the

starter kill is armed. If the system was installed with the starter kill option, you will not be able to

start the vehicle with the key unless the system has been unlocked first or put into Valet Mode

(page-12)

Note: If the Starter Kill is installed, the vehicle will benefit from a protection against starter

motor damage that could occur after remote-starting the engine should the user, by force of

habit, turn the ignition key to the CRANK position.

The Starter Kill (if installed) can be configured by the installer either to Passive Mode (so as to arm

automatically) or Active Mode (so as to require the user's intervention for arming). By default, your

Remote Car Starter is configured to Passive Mode.

Passive mode:

To arm the Starter Kill, press the

button on the transmitter, OR

In Passive Mode, the Starter Kill will automatically arm 1 minute (by default) or 3

minutes (if configured this way) after the ignition is turned OFF or once the last door is

closed (if the doors are monitored).

The LED on the antenna will flash quickly during the countdown preceding the activation

of the Starter Kill.

Once the activation countdown expires, the LED will send a series of quick double

flashes to indicate that the Starter Kill is now armed.

To disarm the Starter Kill, press the

button on the transmitter.

The Starter Kill will automatically rearm itself after 1 minute (by default) or 3 minutes (if

configured this way) if no door is left opened (if the doors are monitored) and the ignition

is not turned ON.

Active Mode:

To arm the Starter Kill, press the

button on the transmitter.

The parking lights will flash once.

The LED on the antenna will flash slowly.

If remote door locks are installed, this will also lock the doors and arm the OEM-style

alarm.

To disarm the Starter Kill, press the

button on the transmitter.

The parking lights will flash twice.

The LED on the antenna will remain OFF.

If remote door locks are installed, this will also unlock the doors.

P.10

button to disarm and unlock the

User Guide