Clarke 01193B Operatör El Kitabı - Sayfa 6

Zemin Makinesi Clarke 01193B için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Clarke 01193B 20 sayfaları. Ultra speed burnisher

ABOUT THE MACHINE

How To Assemble

This machine is shipped with the handle assembly

separate from the base. Assemble as follows:

1. Loosen but do not remove the two square head knobs

on the rear of the machine.

2. Insert the handle tube between the frame and handle

clamp until it bottoms.

3. Tighten the two square head knobs to secure the

handle tube.

4. Connect cord set to the motor pigtail.

Install a pad and the machine is ready to operate.

HOW TO PREPARE THE MACHINE

FOR OPERATION

How To Install the Pads

WARNING: Always remove the electrical

plug from the electrical outlet

before installing or changing the

pad.

The pad driver assembly is on the bottom underside of

the machine. The pad holder holds the pad in position.

The machine has a screw-on pad holder. To install the

pad, follow this procedure:

1. With the handle locked in the operating position, tilt

burnisher back on the handle until the underside of the

burnisher is fully exposed. (See figure 2).

2. Remove the retainer from the pad holder by unscrewing

(turn counterclockwise).

3. Remove the center scored circle from a pad.

4. Place pad on pad driver.

5. Be sure pad is properly centered on the driver.

6. Reinstall the retainer on the pad holder until pad is

tightly secured (turn clockwise).

NEVER OPERATE BURNISHER WITHOUT A PAD.

Page - 6 -

CLARKE TECHNOLOGY Operator's Manual - Ultra Speed Burnisher 1700

Figure 2