California Patio Gas BBQ Grill Kullanıcı El Kitabı - Sayfa 9

ızgara California Patio Gas BBQ Grill için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. California Patio Gas BBQ Grill 12 sayfaları. Gas bbq grill

Sayfayı Yazdır

Diagram 7

Take the complete burner (4) with the venturi pipes (2) and the

ignitor collector box (3) and stick it from above with the venturi

pipes down through the big opening (1) in the bottom casting.

Take care that the venturi pipes (9) slide over the nozzles (8)

of the valve which is fixed on the front panel (small diagram).

CAREFUL : The ends of the pipes sit loose on the nozzles! - This space is necessary for the airflow.

Now screw together both legs of the burner with two steel screws (6) from below to thebottom casting.

Then pass the cable of the ignition box (3) on the shortest way down through the bottom casting.

Connect the ignition wire which is connected with the ignition box to the burner (4) in the bottom

casting (5) to the back of the ignitor push button (7) in the front panel.

Diagram 8

Open the lid (1) and insert the pivot wires of both

warming racks (2). As shown, first into the left lid holes,

and then the right lid holes. Now swing the warming rack

to the front, and insert the lower pivots into the rearmost

holes in the bottom casting (3) on both sides.

page 9