Directed Electronics 29402 Kullanıcı Kılavuzu - Sayfa 5

Güvenlik Sistemi Directed Electronics 29402 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Directed Electronics 29402 8 sayfaları. Vats / passlock / transponder universal alarm bypass module

Sayfayı Yazdır

duplicated. Repeat this step several times to verify that you have a

consistent reading.

8. When you have identified the correct resistance use the chart on page

4 to set the resistance on the bypass module. Locate the closest value

which is less than your desired value. Set dip-switches 2 through 6 to

match the chart on page 4 with this value.

9. Put your ohm meter (multi-meter) probes on the two silver resistance

measuring pads through the opening shown in the drawing -- making

good contact with these two silver pads on the board. (See drawing on

page 1). Or put your two probes into the two holes on the bottom of the

case making contact with the underside of the silver pads. Either con-

tact point method will work.

10. With the probes held firmly -- dial-in the final resistance value needed

for your system by turning the screw on the variable resistor on the

side of the unit next to the dip switches. Turn the screw until the resis-

tance value matches the resistance value of the key.

11. Connect the bypass module using the diagram on the next page. Be

sure to tape over any connections to not leave any exposed wires.

To verify that this installation is correct -- hold the WHITE/GREEN wire

and the GRAY/BLACK wire to ground and start the vehicle with the key.

If the vehicle starts and stays running - the installation is correct.

Dip Switch #1 Off

Dip Switch #7 Off

Dip Switch #8 Off

*See page 12 if you do not have an IGN3 wire

v2.1

WHITE/GREEN TO WHITE/BLACK

IGN 3 output from car starter (or

to constant negative ground

output when remote starter is

SATURN:

Saturn vehicles up to the 2000 model year with factory

keyless entry have a unique bypass.

1. Set all dip switches to the OFF (up) position.

2. Locate the Alarm Module behind the right rear quarter trim

panel (trunk area). Connect the Pink and Yellow/Black

wires of Connector J and D of the alarm module as shown.

3. Cut the Pink wire in half and connect as shown.

*See page 12 if you do not have an IGN3 wire

Dip Switch #1 Off

Dip Switch #7 Off

Dip Switch #8 Off

WHITE/GREEN TO WHITE/BLACK

IGN 3 output from car starter (or to

constant negative ground output

when remote starter is activated).*

v2.1