Directed Electronics 9400T Kullanıcı Kılavuzu - Sayfa 2
Otomobil Elektroniği Directed Electronics 9400T için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Directed Electronics 9400T 2 sayfaları.
Warning Buzzer
The buzzer should be mounted in an area inside the
vehicle where it can be heard clearly by the driver.
The control module should be located in the trunk
area securely mounted away from any moving parts
and in an area free of moisture and heat
Wiring Instructions
RED Wire - Connected to the wire that
provides (+)12V when the vehicle's
reverse light is on.
BLACK Wire - Connected to ground.
RED Connector - The buzzer is plugged
into this port.
WHITE Connectors - The sensors are
plugged into these ports.
(+)12V
RED
BLACK
4
3
2
1
REVERSE
LIGHT
SENSOR 4
SENSOR 3
BUZZER
SENSOR 2
SENSOR 1
Testing
NOTE: To avoid incident during testing, a second person
should watch the rear of the vehicle.
Place the gearshift in reverse. The buzzer will
emit two quick beeps indicating the system is on.
Back up the vehicle slowly.
The first beep pattern indicates the vehicle is 5 ft.
to 5.5 ft. away from the nearest obstacle. As the
vehicle gets closer to the object, the buzzer emits
a different beep patterns. Please refer to the
Detection Range chart for pattern description.
Be aware that certain shapes will mislead the
sensor and it is necessary to test the sensor
backing up against multiple shaped objects.
Objects with a rounded smooth surface may
mislead the reflecting signal.
Detection Range
Detecting
Stage
Distance
1
5.5 ft. to 5 ft.
2
5 ft. to 3.25 ft.
3
3.25 ft. to 2.25 ft.
4
2.25 ft. to 1.5ft.
5
1.5 ft. to 1 ft.
6
1 ft. to 0 ft.
NOTE: Stop the vehicle when the buzzer makes a constant
sound.
Buzzer Sound
Two Beeps
Three Beeps
Four beeps
Five beeps
Three beeps then
four quick beeps
One long beep
© 2003 Directed Electronics, Inc.
N9400T 3/03