Directed Electronics Valet 9405T Kullanıcı Kılavuzu - Sayfa 9

Otomobil Elektroniği Directed Electronics Valet 9405T için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Directed Electronics Valet 9405T 9 sayfaları. Back up sensor

Sayfayı Yazdır

Ensure that the engine is not running while proceeding

with the following tests.

Test the system operation with a piece of wood

(8 inches wide x 3 feet, 3 inches high) after the

installation. Start with the wood more than 8.4

feet away from the vehicle. Then move the wood

closer to the vehicle and ensure that both the

audible, LED, and distance indicators display cor-

rectly.

8.4Ft

T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g

No beep at power up or no LEDs flashing

1. Is power wire connected to ECU correctly?

2. Verify (+)12V at ECU when vehicle is in

reverse.

3. Verify the ground connection

4. Have you connected to the correct reversing

indicator wire?

5. Do you have a minimum of (+)12V and ground

at the display?

False warning tone or false LED flashing

1. Is the sensor mounted too low or pointing to

the ground?

Sensors do not detect any objects

1. Is the vehicle's exhaust smoking? Correct or

allow it to clear before proceeding with

testing.

2. Are sensors properly plugged into the correct

sockets?

If the problem persists, please follow these steps:

1. For consumers: Contact your dealer

2. For Installer or dealer:

a. Replace the ECU and re-check the system.

b. Test the sensors with a known operative

ECU and retest using the flat wooden

board.

c. Plug the known operative sensors into the

ECU and re-check.

d. Contact Directed tech support.

9 9

N9405T 11-05