Clarke TFC 400 Operatör El Kitabı - Sayfa 4

Zemin Makinesi Clarke TFC 400 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Clarke TFC 400 13 sayfaları.

KNOW YOUR MACHINE DESCRIPTIONS

Operator Handle (1): Operator holds onto this handle to move the machine from one location to

another.

Solution Tank Lid (2): This lid screws off so the tank can be ﬁ lled. The solution ﬁ ll hose is

tethered to the lid, and hangs inside the arm of the Operator Handle.

Tools & Accessories (3): Various accessories can be stored on the machine.

Basket (4): This lift-off carrying basket sits on top of the round lid on the Recovery tank.

Recovery Hose (5): Waste water is picked-up through this hose.

Chemical Container Holders (6): Two molded-in bottle holders for chemical jugs.

Spray Hose (7): This hose delivers water from the machine to the cleaning tool.

Drain Hose (8): This hose is used to empty the recovery tank. NOTE: hold the end of the hose

above the water level in the tank to avoid sudden, uncontrolled ﬂ ow of waste water when you

remove the cap, then lower the hose slowly to control the rate of discharge.

Quick Disconnect (9): Point of attachment for the Spray Hose (7).

Switch Plate (10): The machine's on/off switches for the vacuum and for the pump are located

here and this is where the valve to change chemical feeds is located.

Castors and Wheels (11): Castors pivot for ease of steering, and large back wheels make it

easy to roll the machine from location to location.

Switch Plate (10): The machine's on/off switches for the vacuum and for the pump are located

here and this is where the valve to change chemical feeds is located.

Power Cord (12): The 25 ft. power cord connects to a power cord pigtail on the rear of the

machine.