Clarke 6470168 Kullanım ve Bakım Talimatları Kılavuzu - Sayfa 10
Testere Clarke 6470168 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları Kılavuzu indirin. Clarke 6470168 17 sayfaları. Abrasive cut-off saw
Sayfayı Yazdır
• Allow the disc to reach full speed, then gently lower it on to the work.
DO NOT try to cut too harshly.
Release the trigger to stop the motor.
• The disc will continue to rotate
briefly after switching off.
The machine is fitted with a thermal
overload device which is designed to
cut the power in the event of
overheating. If the machine should
stop after a period of sustained work,
allow it to cool down for a few
minutes before pressing the Thermal
Reset button shown.
NOTE: Take particular care when cutting with a new disc. Do not press too
heavily, particularly at the end of a cut.
The depth stop is factory set for a new
14" (355 mm) cutting disc. This can be
adjusted as the disc wears away.
1. Loosen the locking nut.
2. Loosen the depth stop bolt.
3. Adjust the depth stop bolt to
desired height.
Then turn the locking nut until seated
firmly against the casting.
NOTE: Securely tighten the depth stop bolt before use.
TIPS FOR MORE ACCURATE CUTS
• Allow the cutting disc to do the cutting. Excessive force will cause
the cutting disc to glaze reducing cutting efficiency and/or to
deflect causing inaccurate cuts.
• Adjust the fence angle.
• Make sure the workpiece is laying flat across the base.
• Clamp the workpiece securely to avoid movement and vibration.
GENERAL CARE OF THE MACHINE
Take care to keep the ventilation openings clear when working in dusty
conditions. Always disconnect the machine from the power supply before
cleaning the openings using a soft brush if necessary. Refer to your CLARKE
dealer if internal maintenance is required.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
10