Clarke DUO SAW Kullanım ve Bakım Talimatları Kılavuzu - Sayfa 11

Testere Clarke DUO SAW için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları Kılavuzu indirin. Clarke DUO SAW 20 sayfaları. Multi purpose 5”(125mm) twin blade saw

Sayfayı Yazdır

CUTTING CROSS SECTIONAL MATERIAL

The life span of the blade and the quality of the cutting edge is dependent

on vibrations being kept to a minimum. For this reason the material must

always be clamped in place before work proceeds.

Flat bar iron

The blade is fed at an angle of

90° to the work surface

U-section

The blade is fed from corner to

corner.

Pipes

The blade is fed through the

object until it reaches the lower

edge, angled as it goes so that

the blade hits the material at an

angle of 90°.

The Blade Cover Guard is fixed to protect the operator from chips. When the

blades rotates, the chip flow comes out in both directions, which must be

observed.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

Corner piece

The blade is fed diagonally

through the work surface.

Aluminium/copper

The machine must always be

equipped with the lubricating

device, to be used when

cutting all kinds of aluminium

and copper.

Spiral tube and longitudinal

cutting

Feed the blade through the

material, so that the blade only

protrudes through approx. 10

mm, do not drive it as far as the

blade's entire cutting edge.

Then start to feed the blade

forwards or backwards.

Rectangular pipe

The blade is fed from corner to

corner.

Shaped plate

The plate must always rest on

three mounts, with one on either

side of the cut.

Thin plate

Only feed the blade down

approx. 10 mm. Then start

cutting.