Clarke Air CAT62 Kullanım ve Bakım Talimatları - Sayfa 8

Araçlar Clarke Air CAT62 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları indirin. Clarke Air CAT62 17 sayfaları. Punch & flange tool

OPERATION

1. Connect the tool to the air supply.

2. To start the tool, hold firmly and squeeze the throttle lever.

• The clamp will move down, punching a hole or forming a flange, as

required.

3. Release the lever and the clamp will rise allowing the tool to be positioned

for the next operation.

4. After use, disconnect the tool from the air supply, clean and store in a safe,

dry, childproof location.

NOTE: It is recommended that a whip hose with a swivel (not included)

be used to prevent twisting, kinking and resultant wear to the air

hose.

Do not disconnect the air supply hose until the compressor has been shut

down and the compressed air released.

1. Refer to the compressor instruction manual for the procedure to shut down

and release the compressed air.

2. Once the pressure has been released, disconnect the air supply hose from

the air tool.

3. Store the tool safely in its box in a dry, secure environment.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]