Clarke CAT151 Kullanım ve Bakım Talimatları - Sayfa 7

Araçlar Clarke CAT151 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları indirin. Clarke CAT151 17 sayfaları. Air/hydraulic riveter

PREPARATION & ADJUSTMENT

FILLING/CHECKING THE OIL LEVEL

Before use, check that the rivet gun is topped up with hydraulic oil (not

supplied) after removing the cylinder cap and piston assembly to ensure that

it is properly lubricated.

1. Disconnect the riveter from the air

line.

2. Hold upside-down and remove the

air cylinder cap (fig 1) with the

spanner provided.

3. Remove the air/hydraulic piston

assembly (grip the exposed nut

and pull up) as in Fig 2.

4. Add hydraulic oil to the hydraulic

cylinder until the level is just below

the connection with the air

cylinder. See fig. 3.

• Hydraulic oil is avaialble from

your Clarke dealer: part No

3050830 (1 litre).

5. Lightly lubricate the inner wall of

the air cylinder.

6. Replace the air/hydraulic piston

assembly and press in as far as it will go.

7. Refit and tighten the air cylinder cap.

CHECKING/ADJUSTING THE STROKE

1. Check that the hydraulic oil level is

correct as above.

2. Remove the outer cylinder using

the spanner provided.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]