CTM LYNG microsafe mKomfy 1.8 16R Kurulum Talimatları Kullanıcı Talimatları - Sayfa 11
Güvenlik Ekipmanları CTM LYNG microsafe mKomfy 1.8 16R için çevrimiçi göz atın veya pdf Kurulum Talimatları Kullanıcı Talimatları indirin. CTM LYNG microsafe mKomfy 1.8 16R 12 sayfaları.
Sayfayı Yazdır
Installation – Calibration and function test
Calibrating electricity consumption
If the yellow LED on the SOCKET comes on continuously when the hob
is OFF and does not disappear when the control button on the sensor is
pressed, the cooker's standby current is higher than the Cooker Guard's
preprogrammed standby level.
In this case the level can be recalibrated to actual electricity
consumption by:
1.
Holding the SOCKET's control button in until the red and green LEDs
flash – then release the button within two seconds.
2. The green LED flashes three times to acknowledge the change.
NB: We strongly recommend measuring the hob's electricity
consumption in standby BEFORE doing this calibration. High electricity
consumption could be caused by a fault in the hob. Incorrect calibration
the case of high electricity consumption can result in the Cooker Guard
never starting or not working as intended.
Function test
There are two different function tests: 1 = On/Off test 2 = Current test.
To activate the function test:
1.
Remove the SENSOR cover and set DIP switch 0 to ON
2. Put the cover back on temporarily to stop the batteries falling out.
To change between the two function tests, hold the control button on
the SENSOR in for five seconds.
The sensor acknowledges with one or two beeps to indicate the test type.
1 beep
On/Off test
The sensor acts as an
ON/OFF switch.
Pressing the control button
switches between turning the
power to the cooker ON/OFF.
The light on the SENSOR comes
on when the cooker socket is on
(sending power to the cooker).
When you have performed the function test(s), remember to set DIP
switch 0 to OFF.
NB: May only be carried out by
an authorised electrician.
2 beeps
Current test
Indicates electricity consumption for
the hob.
Following activation turn the hob on ON.
A few seconds later the red LED on the
SENSOR should come on continuously
and the green and yellow LEDs on the
SOCKET should light up.
Now turn the hob off. The red LED on the
SENSOR goes out and only the GREEN
LED on the SOCKET should be on.
11