Claro SUMMER DC Kurulum Kılavuzu - Sayfa 12

Fan Claro SUMMER DC için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Claro SUMMER DC 15 sayfaları.

a. Please check the battery to ensure it has sufficient power and has been inserted correctly and

aligns with the positive and negative terminals; or

b. Please check if there are any other similarly remote controlled objects that work nearby, as

remote controlled items operating on the same frequency may disturb each other.

2) If the battery is low it will affect the sensitivity of the remote control and the signal reception and

must be replaced (the LED indicator light will flash a warning when the battery runs low).

3) Please remove the battery if the remote control is not being used for a long time.

4) If multiple fans are installed near the fan to be paired, power to the other fans should be turned

off before pairing.

Considerations when installing multiple ceiling fans:

Sometimes you may encounter a remote control issue when installing multiple fans. For the

purposes of this troubleshooting guide:

Fan A uses Remote control A and Receiver A, while Fan B uses Remote control B and Receiver B.

Isolate power to one fan only when pairing the remotes

When installing two or more fans, you should manually isolate power to Fan B while completing the

pairing process on Fan A. If power is not isolated to one of the fans when the power is restored at

the fuse box, then both receivers will be put into "learning mode" such that when you try to pair

Remote control A to Receiver A, Receiver B will also be in learning mode and might pair to Remote

control A too.

FUNCTIONS OF THE REMOTE CONTROL

1. Natural wind mode

2. Forward/Reverse (press and hold

for 2 seconds to switch)

3. Speed Control

4. Fan ON/OFF

5. Timer

6. Select Light Colour Temperature

7. Not applicable on this model