Clarrke CNG1C Kullanım ve Bakım Talimatları - Sayfa 5

Çivi Tabancası Clarrke CNG1C için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları indirin. Clarrke CNG1C 11 sayfaları. Air nail gun

AIR SUPPLY

Compressed air can be dangerous. Ensure that you are thoroughly familiar with

all precautions relating to the use of compressors and compressed air supply.

Tools of this type, operate on a wide range of air pressures. It is recommended that air

pressure be set to between 60 and 100psi. at the tool when running.

Higher pressure and unclean air will shorten the tools' life and could be a safety hazard.

Water in the air line will cause damage to the tool, ensure it is properly maintained at all times.

The recommended procedure to connect this tool to an air supply, is shown on page 11.

The air inlet used for connecting air supply, is a 10mm Quick Fit type.

Line pressure, or hose ID., should be increased to compensate for unusually long air hoses

(over 10M). Minimum hose dia. should be 6mm (1/4") ID., and fittings should have the same

inside dimensions.

ASSEMBLY

Ensure the tool is not loaded, then, with the

air supply turned OFF, connect the air line

to the Nailer at the Quick Fit coupling.

With your fingers well away from the trigger,

and the tool pointed away from you, and

anyone in the vicinity, depress the magazine

catch, pull out the magazine and load with

appropriate nails or staples...as shown,

Push the magazine back until it locks in

position, - Your Nailer/Stapler is now ready for

use.

Turn ON the air supply, and check for air

leaks. If any are apparent, rectify before proceeding. Ensure the operating pressure is set

to between 4-7bar (60-100psi), depending upon the size of nail used and type of material

being worked. The harder the material, and bigger the nail, the higher the pressure.

Hold the tool so that it is at right angles to the work. Lower it so that the Safety Element

contacts the work surface, and is forced upwards. This movement releases the Trigger,

which may now be pulled, driving in the nail.

CLEARING A JAM

Should the gun jam, turn OFF the air supply and pull the trigger in order to ensure the

airline is not under pressure. Release the nose catch (A Fig. 1), and clear the jammed nail

from the within the nose. Secure the nose with the catch, turn ON the air supply and

proceed to use the Nailer.

WARNING!

Nails

CSG2K

CSG3K