CLAS OH 6014 Manuel - Sayfa 7

Jacks CLAS OH 6014 için çevrimiçi göz atın veya pdf Manuel indirin. CLAS OH 6014 12 sayfaları. Extra low profile service garage jack 2.5t 75mm

OH 6014

EXTRA LOW PROFILE SERVICE GARAGE JACK 2.5T 75mm

4. Turn the release valve clockwise to the closed position. DO NOT OVER TIGHTEN.

5. To raise the vehicle to desired height, place the handle into the socket and pump up and down.

6. Place jack stands beneath the vehicle at locations recommended by the vehicle manufacturer. Do

not get under the vehicle without jack stands. Jacks are not designed to maintain heavy loads for long

periods of time.

7. Turn release valve SLOWLY counter clockwise to lower load onto jack stands.

Lowering vehicle:

1. Turn the release valve clockwise to the closed position.

2. Pump the handle to lift vehicle off of jack stands.

3. Remove the jack stands. Do not get under or let anyone else under the vehicle while lowering.

4. Turn the release valve SLOWLY counterclockwise to lower the vehicle onto the ground.

The product shall be maintained in accordance with the instruction manual. No alterations shall be made

to this product.

1. Before use, a visual inspection of the jack should be made for abnormal conditions such as cracked

welds, bent, worn, lose or missing parts, or hydraulic leaks.

2. The product shall be inspected immediately if the jack is believed to have been subject to an abnormal

load or shock. It is recommended that the inspection is made by an authorized repair technician prior to

use.

MAINTENANCE

Monthly maintenance is recommended. Lubrication is important to jack as they support heavy loads. Any

restriction due to dirt, rust, etc, can cause either slow movement or extremely rapid jerks, damaging the

internal components.

The following steps designed to keep the jack well lubricated.

1 - Lubricate the ram, linkages, saddle and pump mechanism with light oil. Grease wheel bearings and

axles.

2 - Visually inspect for cracked welds. bent, loose, missing parts or hydraulic leaks.

3 - If the jack is subjected to an abnormal load or shock, remove from service and have it examined by an

authorized repair technician prior to use.

4 - Clean all surfaces and maintain all labels and warnings.

5 - Check and maintain the ram oil level.

6 - Check ram every 3 months for any sign of rust or corrosion. Clean as needed and wipe with an oil

cloth. When not in use, always leave the saddle and ram all the way down.

Always store the jack in a fully lowered position. This will help protect critical areas from excessive

corrosion. Do not use brake or transmission fluids or regular motor oil as they can damage the seals.

Always purchase and use products labeled hydraulic jack oil.

Check oil level

1 - Turn release valve counterclockwise allow ram to fully retract. It may be necessary to apply force to

the saddle for lowering.

2 - With the jack in a level position, remove the Fill Screw and Screw. The oil should be level with the

bottom of fill hole. If not, top off. Do not overfill. Always fill with new, clean hydraulic jack oil.

3 - Replace Fill Screw and Screw

4 - Check jack operation.

5 - Purge air from system as required.