Lenovo S750 Kullanıcı Kılavuzu - Sayfa 40

Cep Telefonu Lenovo S750 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Lenovo S750 41 sayfaları.

Sayfayı Yazdır

User manual

FCC Statement

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may cause undesired

operation.

2. Changes or modifications not expressly approved by the party responsible for compliance could void

the user's authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

SAR Information Statement

Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed

the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications

Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish

permitted levels of RF energy for the general population. The guidelines are based on standards that

were developed by independent scientific organizations through periodic and thorough evaluation of

scientific studies. The standards include a substantial safety margin designed to assure the safety of all

persons, regardless of age and health. The exposure standard for wireless mobile phones employs a unit

of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6

W/kg. * Tests for SAR are conducted with the phone transmitting at its highest certified power level in

all tested frequency bands. Although the SAR is determined at the highest certified power level, the

actual SAR level of the phone while operating can be well below the maximum value. This is because

the phone is designed to operate at multiple power levels so as to use only the power required to reach

the network. In general, the closer you are to a wireless base station antenna, the lower the power

output. Before a phone model is available for sale to the public, it must be tested and certified to the

FCC that it does not exceed the limit established by the government adopted requirement for safe

exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body) as

required by the FCC for each model. The highest SAR value for this model phone when tested for use

at the ear is 0.139W/Kg and when worn on the body, as described in this user guide, is

0.33W/Kg(Body-worn measurements differ among phone models, depending upon available

accessories and FCC requirements). While there may be differences between the SAR levels of various

phones and at various positions, they all meet the government requirement for safe exposure. The FCC

has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as

in compliance with the FCC RFexposure guidelines. SAR information on this model phone is on file

with the FCC and can be found under the Display Grant section of http://www.fcc.gov/ oet/fccid after

searching on

FCC ID: ZSW-S750 Additional information on Specific Absorption Rates (SAR) can be found on the

Cellular Telecommunications Industry Asso-ciation (CTIA) web-site at http://www.wow-com.com. *

In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg

(W/kg) averaged over one gram of tissue. The standard incorporates a sub-stantial margin of safety to