Nikon D200 Kullanıcı Kılavuzu - Sayfa 8

Kamera Aksesuarları Nikon D200 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Nikon D200 19 sayfaları. Exploring
Ayrıca Nikon D200 için: Broşür ve Teknik Özellikler (13 sayfalar), Broşür (7 sayfalar), Kurulum Kılavuzu (2 sayfalar), Broşür ve Teknik Özellikler (18 sayfalar), Broşür (14 sayfalar), Teknik Özellikler (2 sayfalar), Özellikler & Karşılaştırma Tablosu (1 sayfalar), Teknik Özellikler (2 sayfalar), Kullanım Kılavuzu (23 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Manuel (25 sayfalar), Hızlı Başlangıç Kılavuzu (9 sayfalar)

5. Port with bayonet catch

The front port bayonet catch is a secure and fast method to connect the dif-

ferent ports to the HUGYFOT Nikon D200 housing.

The port has a mark which has to be positioned opposite to the mark at the left

of the housing when mounting and demounting the port. To actually close the

port it has to be turned clockwise until the mark on the port is opposite to the

mark on top of the housing. To demount the port it has to be turned counter

clockwise until the mark on the port is opposite to the mark on the left of the

housing.

When mounting the port, mind that it is held exactly in the middle of the

port mounting. Only then you can press the port so it slides nicely into the

port mounting. Check whether the port is closed properly before turning it

towards the marking on top of the housing. (secure position).

Third maintenance command:

The o-ring around the port can be removed from its groove by pressing it

with 2 fingers.

Port mounting, o-ring groove and bayonet catch have to be cleaned with a

wet cloth. Afterwards let everything dry.

Clean the inside of the portglas with water and soap. Never scrub it with a

cloth. Rinse it with fresh water and let it dry, or dry it with compressed air.

Grease the O-rings with HUGYFOT grease by gently pulling it through your

fingers without stretching it! Put it back into their grooves.

Hugyfot Housing for

Nikon D200

When mounting the port,

A and C must be opposite

to each other. Make sure

that the port is held ex-

actly in the middle of the

port mounting. Then turn

the port clockwise until B

and C are opposite to each

other.

User manual