Nikon DS-Ri1 Talimatlar Kılavuzu - Sayfa 16

Kamera Aksesuarları Nikon DS-Ri1 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Nikon DS-Ri1 49 sayfaları. Ds camera control unit/camera heads
Ayrıca Nikon DS-Ri1 için: Talimatlar Kılavuzu (49 sayfalar)

Sayfayı Yazdır
Nikon DS-Ri1 Talimatlar Kılavuzu
Chapter 4
Connecting and Installing the Equipment
2

Installing the DS-U2

Installing the DS-U2
2
The DS-U2 can be positioned either horizontally or vertically.
• Horizontal installation
Set the DS-U2 horizontally on a flat surface.
Provide a clearance of approximately 100 mm around the product to dissipate heat.
• Vertical installation
Attach the vertical stand to the DS-U2 for setting the product in the vertical position.
Set the DS-U2 vertically on a flat surface as shown below.
Provide a clearance of approximately 100 mm around the product to dissipate heat.
Attach the vertical stand as follows:
Remove the two screws at the upper front position and the lower rear position among four screws
on the right side of the DS-U2. (See Figure A below.)
Then, fix the stand to the right surface of the DS-U2 using the removed screws. (See Figure B
below.)
Use an M2.5-size Phillips driver to attach or detach screws.
Figure A
Figure B
- 10 -