Nikon eclipse Ti-U Talimatlar Kılavuzu - Sayfa 25
Mikroskop Nikon eclipse Ti-U için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Nikon eclipse Ti-U 25 sayfaları. Inverted microscope
Sayfayı Yazdır
1.7.2
TE-PS30W Power Supply A (for 100-120V)
TE-PSE30 Power Supply A (for 220-240V)
Warning
•
Before turning on the power supply, check that the input voltage indicator matches the
power voltage in your area. If the voltages do not match, do not turn on the product, and
contact Nikon. Use of the product under a wrong voltage may result in malfunction or fire.
•
The bottom of the power supply device becomes hot during use. Do not block the air vents
on the side of the product.
Brightness control
knob
POWER
switch/indicator
POWER switch/indicator
This is the power switch for the power supply. Press
the "I" side of the switch to turn on the power supply
and output DC power from the 6VDC output on the
rear. The switch is lit when the power supply is on.
Press the "O" side of the switch to turn off the power
supply.
Brightness control knob
When the CTRL switch is turned off, this knob
controls the brightness of the lamp by adjusting the
voltage output from the 6VDC output connector.
AC inlet
This is the connector for connecting the power
supply device to a wall outlet. Be sure to use the
specified power cord for the connection.
CTRL (external control) ON/OFF switch
Turn this switch on to use the brightness control
knob on the microscope for output voltage control.
When this switch is turned off, the brightness control
knob on the front of the power supply becomes
enabled, and the brightness control knob on the
microscope becomes disabled.
Chapter 1 Part Names
1.7 Power Supply
AC inlet
Figure 1-23 TE-PS30W, TE-PSE30 Power Supply A
CTRL (external control signal input) connector
Connect the control cable to this
connector and the LAMP CTRL
connector on the rear of the
microscope.
Pin Signal
External resistor terminal for output voltage adjustment
1
External resistor terminal for output voltage adjustment
2
Output voltage ON/OFF switch (input)
3
GND (0V)
4
Not used
5
Not used
6
Not used
7
Not used
8
Connector: HR12-10R-8SC by Hirose Electric Co., Ltd.
6VDC output connector
This connector supplies power to the 6V 30W
halogen lamp. Connect the lamp cable for the pillar
illuminator.
2
1
3
Connector: SRCN2A13-3S by Japan Aviation Electronics Industry, Ltd.
23
CTRL ON/OFF switch
6VDC output connector
CTRL connector
1
2
3
4
5
6
7
8
Pin
Signal
Output -
1
Not used
2
Output +
3