Nikon PROSTAFF 3i Kullanım Kılavuzu - Sayfa 10

Ölçüm Cihazları Nikon PROSTAFF 3i için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Nikon PROSTAFF 3i 39 sayfaları.

Sayfayı Yazdır

Others

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules and to EU EMC directive. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

　• Reorient or relocate the receiving antenna.

　• Increase the separation between the equipment and receiver.

　• Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

This Nikon Laser Rangefinder is a basic rangefinder. Its results cannot be used as official evidence.

Troubleshooting/Repair

If your Nikon Laser Rangefinder should require repair, please contact your local dealer or the store where you

purchased it. Before doing so, you are advised to consult the Troubleshooting/Repair Table below.

Symptom

●

Depress POWER ON/Measurement button. (near side, top of the body)

Unit does not turn on

●

Check the battery insertion

(LCD fails to illuminate)

●

Replace the battery with a new one.

●

Be sure that nothing, such as your finger or a strap, is blocking the laser

emission aperture and laser detector aperture on the objective lens

side.

●

Be sure that the laser emission aperture and laser detector aperture on

Unable to measure the distance

the objective lens side are clean. Clean them if necessary.

●

Be sure that the target shape and condition are appropriate to reflect

the laser beam.

●

Replace the battery with a new one.

●

Be sure to hold the unit steady while measuring.

[- - -] ("Cannot measure") appears

●

Be sure the target is within measurement range.

Closer target, located inside the

●

Be sure that nothing, such as leaves or grass, is between the Nikon Laser

measurement range, cannot be

Rangefinder and the target.

measured

●

Target beyond a certain distance

Be sure that nothing, such as leaves or grass, is between the Nikon Laser

cannot be measured

Rangefinder and the target.

●

Replace the battery with a new one.

●

Be sure that the target shape and condition are appropriate to reflect

the laser beam.

Measurement result is unstable

●

Be sure to hold the unit steady while measuring.

●

Be sure that nothing, such as leaves or grass, is between the Nikon Laser

Rangefinder and the target.

Check Points