Nikon Nikonos Speedlight SB-103 Kullanım Kılavuzu - Sayfa 15
Kamera Flaşı Nikon Nikonos Speedlight SB-103 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Nikon Nikonos Speedlight SB-103 28 sayfaları.
Ayrıca Nikon Nikonos Speedlight SB-103 için: Kullanım Kılavuzu (29 sayfalar)
Sayfayı Yazdır
the
"
normal
"
positioning mark
@
on the flash head
positioning
scale.
The
"normal
"
position is used for
shooting between 1 m (3.3 ft) and
infinity.
For
close-up
shooting within approximately 1 m
(3.3ft),
loosen the
jOint
knob,
point the flash head toward the subject
,
then
tighten the
joint
knob.
In
addition to the
"
normal
"
posi-
tion mark on the flash
head
positioning scale
, "
O.6m
(2ft)"@
and "O.3m (1 ft)"
@
positionmarksareprovided
for use when shooting subjects at these
distances.
However,
when the flash head is not in the "normal
"
position
,
the joint must be attached to the top of the arm
or the flash head will not be pointed at the subject.
To detach
the joint from the
speedlight,
turn the
joint
knob counterclockwise and slide the joint plate out of
the joint
collar
while pulling the joint knob
.
cord or when washing the speedlight with the speedlight
plug
removed from
the
synchro socket, attach the
synchro socket cover to
protect
the socket. To attach
the socket
cover,
press it against the socket to seat the
O-ring
,
then turn its locking ring clockwise as far as
.
it will go
.
•
T
o simplify identifica
tion,
both the
tip
of
the
sync
cord
's
speedlight plug
and the inside of the synchro
socket
are
color·coded
yellow.
Synchro Socket
@
To
connect the sync cord
®
to the
speedlight,
remove
the synchro socket cover
®
by
turning it
counterclock-
wise and pulling it
up.
Remove
the dust-proof plastic
cap from the sync cord 's speedlight plug
®
(black
locking
ring).
Insert the speedlight plug into the synchro
socket after aligning the synchro socket
index
®
with
the red
index
on the speedlight
plug.
When the speed-
light
plug
is inserted, turn its locking ring clockwise as
far as it will go to secure the
plug.
Never submerge the speedlight in water with the
synchro socket cover removed or get the sync cord
plugs wet. Always make
sure the sync cord plugs are
securely attached before entering the
water.
After shooting underwater, wipe off any water droplets
with a soft cloth
before
removing the plug to prevent
water from entering the socket.
When
not using the sync
15