Nikon Nikonos Speedlight SB-103 Kullanım Kılavuzu - Sayfa 22
Kamera Flaşı Nikon Nikonos Speedlight SB-103 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Nikon Nikonos Speedlight SB-103 28 sayfaları.
Ayrıca Nikon Nikonos Speedlight SB-103 için: Kullanım Kılavuzu (29 sayfalar)
Sayfayı Yazdır
IN DETAIL-continued
_ _ _ _
Irl~~~
-~~~=-
'
Cord Fastening Hanger
@
This hanger secures the sync cord to the bracket to
keep it out of the way while shooting
.
To use the cord fastening
hanger,
attach it to the speed-
light bracket as shown in the
photo,
then attach the
sync cord to the
hook.
Attaching
To attach the
adapter,
align the adapter 's mounting
notches with the adapter mounting catches on the flash
head,
push the adapter onto the flash head as shown
in the
photo,
then turn the adapter clockwise as far as
it will
go.
To
remove: Turn the adapter counterclockwise and pull
it off.
o
To prevent the loss
of
the
SW-l
03 and to enable it to be
attached
quickly,
tie one end of
a
piece of
string
to
its
hole and tie the other end to the
speedlight.
22
Wide-Flash Adapter SW·103
@
Designed specifically for use with this flash
unit,
the
Wide-Flash Adapter 8W-103 increases the 88 -103's
angle of coverage from that of a 28mm
lens
(on land
and underwater) to that of a 15mm lens
(underwater).
When the adapter is
attached,
the 88-103's GN
is
reduced to 14 on land and 7 underwater (when using
A8A/180 100 film at
" MFULL" ).
o
T
o prevent overexposure during close-up shooting within approximately
O.6m
(2ft!,
attach the adapter even if using
a
lens
other
than the
UW-Nikkor 15mm
fI 2.BN.
Multiple Flash Photography
The optional Double Flash 8racket and Double 8ync
Cord enable two
88
-103 8peedl ights
(or.
an 88-103 and
an 88-102)\0 be used at the same time
.
When shooting
with a
Nikonos-V,
either the TTL mode or one of the
manual modes can be selected
;
when shooting with
a Nikonos IV-A or III
,
only manual operation is
possible.
o
The
fla sh head mounted on
the arm that is next to
the
camera's film
advance lever can be mounted either
as
shown in Photo 1 or
as
in
Photo
2.
o
lf
you
decide to use only one speedligh
t
in the
TTL
automatic flash
mode,
turn
off the speedlight which is attached to the gray sync
cord.
Should
you turn off the speedlight which is attached to the black
cord,
TTL
automatic flash control is automatically canceled
and
the unit will
fire at its
maximum
output regardless of the
setting.