Dirt Devil DUPLEX DDDS Kullanıcı Kılavuzu - Sayfa 9

Üfleyici Dirt Devil DUPLEX DDDS için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dirt Devil DUPLEX DDDS 17 sayfaları.

OPERATION

Switching on the appliance

WARNING:

cleaned with an electric brush sweeper.

1. Place the appliance down on the floor.

2. Pull the tube towards you, thereby bending down the brush base. The brush base should now be on the

floor however you hold the tube.

505

900

dirtdevil.com.au

Check with your floor manufacturer to see whether your floor type is suited to being

3. Switch on the brush sweeper by moving the slider switch

to the 'I' position - The brush rollers rotate at the medium speed.

NOTE:

short-pile carpets, push the slider switch further down to position 'II' .

The appliance is designed to sweep shortpile carpets alone (e.g. carpet

pile no longer than 5 mm). The appliance does not work on longer

carpet piles.

When the appliance is running you can switch between switch settings

'I' and 'II' as required.

NOTE:

a battery charge for as long as possible (the (II) setting draws more power

from the battery).

NOTE:

longer rotate, the battery pack has to be charged (refer to "Charging the

battery pack", page 7).

Put the slide switch to position '0' .

Move the tube until it is at right angles with the brush base and clicks into

place and the appliance can stand on its own.

Empty the dust container if required (refer to "Emptying the dust

container", page 9).

This should be sufficient for sweeping hard floors. To sweep

We recommend using the medium setting (I) so that you can use

If the battery power has reduced markedly or the brushes will no