Armstrong HEM-1300M Kurulum ve Kullanım Kılavuzu - Sayfa 11

Nemlendirin Armstrong HEM-1300M için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Armstrong HEM-1300M 18 sayfaları. Humidifiers for air handling systems

Sayfayı Yazdır

Multiple Manifolds – See Page 7 for required pipe sizes and dimensions of manifolds with pipe adapter.

Piping Multiple Manifolds – Figure 9-3 below shows the standard installation of reduced size manifold. Note the steam

Figure 9-1. Pipe Connection at Humidifier

Figure 9-3. Piping of Reduced Size Manifolds

Figure 9-4. Piping of Same Size Manifold When All Manifolds Are Above Humidifier Inlet

jacketing is trapped separately and the steam discharge is into a tee, not a cross. A cross will

cause uneven steam distribution from manifold to manifold.

Multiple Manifolds

Figure 9-2. Manifold Pipe Adaptor

Chart 9-1. Header Size of Manifold Piping Out of Humidifier

Separator

Minimum

Size

Pipe Size

92/1200

93/1300

94/1400

Humidifier discharge piping, even with reduced sized

manifolds must be as shown.

When same size manifolds (as the

separator) are used, the piping can

eliminate the drain trap from the

manifold jacket. Note that steam now

discharges into an elbow, not a cross,

and that the manifold steam jackets

are not trapped separately.

Note: The humidifier steam inlet is

below the bottom manifold. If the

bottom manifold is below the

humidifier inlet, piping should be as in

Figure 9-3.

Note: When steam supply pressure is

less than 10 psig and total length of

manifolds is greater than 20 feet, trap

manifolds separately as shown in

Figure 9-3.

Suggested

Header Size