Disaster Area Designs Qconnect Kullanıcı Kılavuzu - Sayfa 8

Kayıt Ekipmanları Disaster Area Designs Qconnect için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Disaster Area Designs Qconnect 16 sayfaları. Multi output midi controller

Sayfayı Yazdır

hase

liss

We figure a lot of folks who pick up qCONNECT will be using them with Chase Bliss Audio

pedals, so we've set them up to work with CBA from the factory.

To configure your Chase Bliss pedals with qCONNECT, plug a TRS / stereo cable from one of the

ports on qCONNECT to the Tap / MIDI jack on the left side of your CBA pedal.

Power the qCONNECT on, but leave the CBA pedal off.

Hold and release the right footswitch on the qCONNECT until the device mode that you want to

use is showing. We usually recommend that the device order match the order that the pedals

are placed in your chain, so for example Brothers might be A, Warped Vinyl would be B, and

Dark World would be C.

Navigate to where you want to start - using our example with Brothers, this

would be the A device mode. The display should show "A" followed by the

preset number.

Power on the Chase Bliss pedal while holding both of its footswitches down.

Release when you see the pedal power on.

Tap the left or right footswitches on qCONNECT until you see the center LED on your CBA pedal

change colors.

That's it! Your Chase Bliss pedal is now configured!

etup

uide

P 01

A 23

A 22