Disaster Area Designs DMC.micro Kullanıcı Kılavuzu - Sayfa 6

Kontrolör Disaster Area Designs DMC.micro için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Disaster Area Designs DMC.micro 12 sayfaları.

(Setting up the DMC.micro, continued)

Finally, you'll need to set up your MIDI devices to recognize the commands that the DMC.micro is sending. This step represents the

part of the "conversation" where you introduce your pedal to the MIDI controller.

This step is different for every type of MIDI device, so the best thing to do is consult the user manual for your device. What we need to

do is to assign each device to the correct MIDI channel, and in some cases map the other control parameters including bypass, tap

tempo, and expression input.

We've included some handy info to help you conﬁgure the most common devices. If you don't see your device listed, don't panic! Just

check its instruction manual to ﬁnd out how to change its MIDI channel. The pedal you want to use as Device A should be assigned to

MIDI channel 1, Device B should be MIDI channel 2 and of course Device C should be MIDI channel 3.

STRYMON

Strymon devices need to be conﬁgured correctly in order to pass incoming data through to the next device in line. They also need to be

set up in order to maintain bypass "trails" and to use the Timeline looper.

Strymon Timeline: Enter the Globals menu and conﬁgure as follows:

MIDITH = ON

MIDICH (Must match device selection - 1 for DevA, 2 for DevB, etc.)

LPEXIT = PLAY

Strymon Mobius and BigSky: Enter the Globals menu and conﬁgure as follows:

MIDITH = ON

MIDICH (Must match device selection - 1 for DevA, 2 for DevB, etc.)

BYPASS = BUFBYP (recommended for BigSky, optional for Mobius)

CHASE BLISS AUDIO

Chase Bliss devices must be set to receive on the correct channel in order to operate with the DMC.micro:

Make sure that the DMC.micro is set to talk to a Chase Bliss pedal on the device (DevA, DevB, DevC) you'd like to use.

Then, make sure that you've got your DMC.micro hooked up to your Chase Bliss with the correct type of cable as described above.

This will either be an MJ-CBA cable, or a MJ-Y-RP1 / RP2, or using a TRS cable with the Chase Bliss / Disaster Area MIDIBox. It'll all

need to be connected before you get to the next step.

Power the DMC.micro on and navigate to the Device mode for the device you want to use, either A, B, or C.

Power on the Chase Bliss pedal while holding both of its foot switches.

Tap the right button until the center LED on the Chase Bliss pedal starts changing colors - this will indicate that the Chase Bliss pedal is

receiving MIDI and is assigned to the correct channel

Disaster Area Designs

MIDIPA = OFF

BYPASS = BUFBYP

MIDIPA = OFF

MIDICT = OFF

DMC.micro

Gen3