DiscMounts Alt-Azimuth DM-6 Teknik Kılavuz - Sayfa 7

Teleskop DiscMounts Alt-Azimuth DM-6 için çevrimiçi göz atın veya pdf Teknik Kılavuz indirin. DiscMounts Alt-Azimuth DM-6 10 sayfaları.

Also the more rigid the ring system is the less vibration will be noticed. Two rings

are better than one. Low profile rings are better than tall rings.

9-If you're taking terrestrial pictures and using low powers to scan, try adding a

little extra friction. Sometimes a little extra friction reassures the mind.

10-This is your mount. Experiment with the friction system! If you have marked

or measured the balance point it's easy to go back.

Sky Commander Installation

Note: When the Sky Commander is ordered at the same time as the DM-6 mount

head the encoders and cable are installed and tested at the factory.

The Sky Commander shelf:

The Top Shelf assembly is installed at the factory with the cable end tucked

inside the top of the Sky Commander mount. Unless otherwise requested the

shelf is mounted so the telescope will mounted on the LEFT side. The shelf may

be pulled back to allow friction adjustment.

Attach the Velcro strip to the back of the Sky Commander and to the top

shelf. Make sure the Velcro does not cover the battery compartment of the Sky

Commander. I have found that installing the Velcro in a cross works best. Place

the Velcro vertical on the shelf and horizontal on the back of the Sky

Commander.

The automatic locking pin can be adjusted by inserting a small flat blade

screwdriver in the hole at the top of one side plate near the logo. Adjust the

tension so the top plate locks when pushed all the way in and releases when

pulled out. Only slight adjustments are needed. When the spring pin is operating

properly you can hear a click as the ball locks in place.

For detailed Sky Commander operation please refer to the Sky Commander

Manual.

Setup parameters (See Sky Commander manual for details):

Hold "Up" and "Down" Arrows while powering up. Use Up/Down arrows to scroll,

Left/Right arrows to select. Use reversing arrow button to enter into memory on

each selection. CAPITAL letters mean the item is selected!

Scope Mount---DOB

Set Hemisphere---NORTH

RA Direction---NORM

DEC Direction---NORM

RA Encoder Res---04000

DEC Encoder Res---04000

FasTrk ON/OFF---OFF

germn

south

rev (REV for Sky Commanders with white face)

rev (telescope mounted on left side)

on (can be on if optional external power is used)