Blade Inductrix200 Kullanım Kılavuzu - Sayfa 13

Quadcopterler Blade Inductrix200 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Blade Inductrix200 17 sayfaları.

Sayfayı Yazdır

Troubleshooting Guide

Problem

Quadcopter will not respond to

throttle

Quadcopter has reduced ﬂ ight

time or is underpowered

Difﬁ culty binding

Difﬁ culty connecting

(after binding)

Crashes immediately upon

lift-off

Quadcopter does not complete

initialization beyond showing

the battery charge level

Static in FPV feed

Charger LED glows solid or

ﬂ ashes blue

Possible Cause

Throttle too high and/or throttle trim

is too high

Throttle channel is reversed

AUX 1 reversed or not set properly

prevents the motors from starting

Motor start command not given

correctly

Flight battery charge is low

Inadequate power to ﬂ ight battery

charger

Flight battery is damaged

Flight conditions too cold

Transmitter too near aircraft during

binding process

Bind switch or button was not held

while transmitter was powered on

Quadcopter or transmitter is too close

to large metal object, wireless source

or another transmitter

Less than a 5-second wait between

ﬁ rst powering on the transmitter and

powering on the quadcopter

The quadcopter is bound to a

different model memory

(ModelMatch™ transmitters only)

Flight battery or transmitter battery

charge is too low

Quadcopter or transmitter is too close

to large metal object, wireless source

or another transmitter

Propellers in wrong locations or

incorrect ﬂ ight mode selected

Aileron, elevator or rudder are

reversed in the transmitter

Quadcopter moved during initialization

Interference on chosen channel

Charging error

Solution

Reset controls with the throttle stick

and throttle trim at the lowest setting

Power the quadcopter off, reverse the

throttle channel on the transmitter, power

the quadcopter back on

Lower the throttle completely and move the

rudder stick completely right then back to

center

Completely recharge the ﬂ ight battery

Use a different power source for the charger

Replace the ﬂ ight battery and follow the ﬂ ight

battery instructions

Make sure the battery is warm

(room temperature) before use

Power off the transmitter. Move the transmitter

a larger distance from the aircraft. Disconnect

and reconnect the ﬂ ight battery to the

Quadcopter. Follow the binding instructions

Power off transmitter and repeat bind process

Move quadcopter and transmitter to another

location and attempt binding again

Leave the transmitter powered on. Power off

the quadcopter and power it back on

Select the correct model memory on the

transmitter. Disconnect and reconnect the

ﬂ ight battery to the quadcopter

Replace or recharge batteries

Move quadcopter and transmitter to another

location and attempt connecting again

Ensure propeller direction and motor direction

are correct

Ensure aileron, elevator or rudder are not

reversed

Allow the quadcopter to sit still until it

initializes completely

Change the video transmitter and receiver

channel per the Using the Micro Camera section

Refer to the Battery Charging section for a list

of error codes