DISCO DAD361 Veri Bakım Kılavuzu - Sayfa 19
Testere DISCO DAD361 için çevrimiçi göz atın veya pdf Veri Bakım Kılavuzu indirin. DISCO DAD361 20 sayfaları. Automatic dicing/cutting saws
Ayrıca DISCO DAD361 için: Bakım Kılavuzu (20 sayfalar)
Sayfayı Yazdır
- 1. Read Carefully before Using this Manual
- 2. Introduction
- 2. Table of Contents
- 3. Contents
- 4. C. General Description of Data Screen
- 5. Important Safety Information
- 5. General Safety Precautions
- 5. Safety Precautions to be Observed During Operation
- 5. Inherently Hazardous Areas and Ways to Avoid Hazards
- 5. EMO Switch
- 5. Operations
1. General Safety Precautions
General safety precautions
This section describes the general safety precautions that should be understood
before operation and observed during operation.
Machine installation environment
Comply with the recommended machine installation conditions
(such as room temperature, humidity or temperature of spindle
coolant water and wheel coolant water). If the machine is installed in
an environment that does not conform to the installation conditions
recommended by DISCO, rust formation may occur due to moisture
condensation or other factor, thereby adversely affecting the cutting
accuracy.
For the recommended environmental conditions, see the section
C-1, [Installation Specifications and Environment] of Installation
Manual.
- Responsibility for instructing workers
- Responsibility for instructing workers who don't seem to understand
- Regular inspection
- Maintenance personnel
Instruct the operators and data maintenance personnel to read the
safety precautions set forth in the Data Maintenance Manual before
proceeding to work.
Also, if the worker performs various tasks, direct them to read the
points of note concerning the safety given in the respective
manuals.
The written instructions for this machine are Installation manual,
Operation manual, Data Maintenance manual, Maintenance
manual and Technical Reference.
the points of note
For the workers who don't seem to understand what is given in the
manuals, explain the safety items described in the chapter so that
they understand what the points mean.
The machine must be inspected on regular basis.
If any accidents occur while an appropriate regular inspection
program is not adhered to, DISCO is not responsible for the results.
Maintenance must be conducted by qualified personnel who have
received the maintenance training.
CAUTION
N O T I C E
A-2