BLADEZ PB-SM 818 Ürün El Kitabı - Sayfa 13

Scooter BLADEZ PB-SM 818 için çevrimiçi göz atın veya pdf Ürün El Kitabı indirin. BLADEZ PB-SM 818 15 sayfaları. Electric power board

CHAIN CARE

Proper chain care will increase the life and improve performance of your Power Board.

Always keep the chain lubricated and tightened to the proper tension.

Lubrication

Always keep the chains lubricated with a good chain spray or grease (not chain wax). If

the chain is allowed to run dry for a prolonged period it will fail, and the life of the chain

will be severely shortened.

Chain Adjustment

The chain on the XTR-COMP II may need to be adjusted from time to time. The chain

should be tight enough not to skip, but have a little bit of play. (About an 8

of an inch) If

you feel your chain skipping or making a popping noise, adjust the tension immediately.

For regular adjustments:

1. Using a 17mm wrench, loosen the axel

bolts on each side of the rear wheel. (Fig. 12)

2. While the axel bolt is loose, using a 10mm

wrench loosen the tension bolts behind the

rear wheel of the XTR-COMP II and pull the

rear wheel backwards to remove the play from

the chain (fig. 13).

3. Once the tension is achieved the axle bolt

must then be relocked into position and wheel

alignment must be checked (while spinning the

wheel, visually check that there is an even

amount of space on each side of the wheel).

*Note: Chains that are run excessively dry or loose can result in sprocket teeth being

severely damaged.

Page 13