Cub Cadet 190 Operatör El Kitabı - Sayfa 6

Çim Biçme Makinesi Aksesuarları Cub Cadet 190 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Cub Cadet 190 12 sayfaları. Grass collection system

Sayfayı Yazdır

Assembly

And

Operation

NOTE:

An extra set of

carriage bolt and lock

nut have been supplied

in your accessory kit.

You may replace the

old hardware for the

chute stop bracket with

these new ones, or

save for later use.

NOTE:

This chute stop

bracket may stay

on the unit even when

the bagger is not

being used.

Attaching Chute Stop Bracket

• Remove the carriage bolt and lock nut holding the

chute stop to the deck. See Inset A of Fig. 2-8. Save

the hardware.

• Replace with new chute stop bracket, from the bag-

ger kit, at the same position on the deck. See Inset

B of Fig. 2-8. Secure with the hardware removed

earlier.

NOTE: An extra set of carriage bolt and lock nut have

been supplied in your accessory kit. You may replace

the old hardware for the chute stop bracket with these

new ones, or save for later use.

NOTE: This chute stop bracket may stay on the unit

even when the bagger is not being used.

Attaching Discharge Chute

• Raise the deck to its highest position.

• Raise the chute deflector (A in Fig. 2-9) on the deck

and hold it while you position the discharge chute

over the chute opening.

• Insert the hinge pin of the discharge chute into the

tube on the chute stop bracket. See B in Fig. 2-9.

• Rotate the chute around the deck so that its front

edge fits snugly into the deck opening. Lower the

chute deflector slowly(C in Fig. 2-9).

• Attach the longer of the three retainer straps on the

discharge chute to the retainer clip on the deck.

Refer to Fig. 2-10.

Figure 2-8

Hinge Pin

Figure 2-9

Attach long

strap here

Figure 2-10

Discharge Chute