Aereco HAT-250-D Teknik ve Bakım Dokümantasyonu - Sayfa 5
Fan Aereco HAT-250-D için çevrimiçi göz atın veya pdf Teknik ve Bakım Dokümantasyonu indirin. Aereco HAT-250-D 12 sayfaları.
Sayfayı Yazdır
TECHNICAL AND MAINTENANCE DOCUMENTATION HAT
2. FAN INSTALLATION
The fans are suitable for outdoor use.
•
All fans must be placed on AERECO vibration isolators and connected to the system
with SAS-1200 silencer.
•
When mounting the fan on the SBC-250 / SBC-250-S roof base, make sure that
the fan housing fits the base gasket properly. The gasket is supplied with the base.
For mounting, use sealing washers for the screws fixing the fan mounting plate to
the roof base. It is recommended to connect the SBC-250 / SBC-250-S base to the
installation with the SAS-1200 silencer.
•
When installing the fan without the SBC-250 / SBC-250-S roof base, a flexible
connector between the fan and the suction duct as well as vibration isolators must
be used. In addition, it is necessary to provide an additional pressure measurement
point and to connect a silicone automation tube to it. The pressure measuring point
should be located in the ventilation duct, but not closer than 1.5 D (D= diameter of
the ventilation duct) from the inlet of the fan.
•
All works inside the fan casing and connected to the power supply and fan automated
system must be carried out after the power supply has been disconnected. The
installer is responsible for the compliance with all applicable safety regulations for
electrical connections and protection against accidental contact.
•
Clearance must be provided around the fan, the automated system and the measuring
stub to allow for future maintenance.
•
The automated control system must be located in an easily accessible place.
•
During installation and storage of the automated equipment, it must be protected
against the ingress of water.
•
During all works connected with the fan service one should
-
use protective gloves,
-
use tools intended for maintenance works.
3. FAN MODELS
HAT-125-1B-HD
www.aereco.com
·
Automated system:
HD
Casing:
Version:
Diameter (mm):
Name of the fan
ATTENTION!!!
Disconnect the fan from
-
the mains supply before
carrying out any installation
or maintenance work.
ATTENTION!!!
Before switching on, the
-
fan must be connected to
the ducting network. The
installation must be performed
in such a way that no contact
with moving parts of the fan is
possible. Installation may only
be carried out by qualified
personnel.
Before starting the fan, check
-
that there are no foreign
objects blocking the impeller.
*
diameter available in casing size B
**
diameter available in casing size B and C
***
diameter available in casing size C
****
diameter available in casing size C and D
5