Blagdon MIDIPOND 14000 Manuel - Sayfa 6

Su Filtrasyon Sistemleri Blagdon MIDIPOND 14000 için çevrimiçi göz atın veya pdf Manuel indirin. Blagdon MIDIPOND 14000 8 sayfaları. Water garden filtration system

Sayfayı Yazdır

Midipond_Inst_AW.qxd

6/2/07

3:20 pm

Page 6

ELECTRICAL INSTALLATION

IMPORTANT:

Please note all electrical work on garden lighting and power installations must comply

with part P of the building regulations. Failure to comply is a criminal offense. If the installation of this

product is not carried out by a competent electrician who is registered under the Part P self-certification

scheme then you must notify the local building control department before work begins. For further

information and guidance on this matter and other electrical installations in your home that might be

covered by the relevant legislation, contact your local authorities building control department.

For permanent installations to the mains supply, it is necessary to conform to the regulations of the local

electricity authority and this would include the use of a metal or plastic conduit to protect the cable.

Attention has been drawn to the fact that special rules may exist concerning the installation of your

pond UVC (i.e. local building regulations).

This UVC must not be used in swimming pools, or areas where people are in contact with the water.

Always disconnect the mains electricity supply whilst the equipment is being installed, repaired, maintained

or handled. Consult a qualified electrician if in any doubt about wiring this product to the mains supply.

Electrical/Safety

UVC Warning: Caution: Dangerous Ultra Violet Radiation. The rays from the UVC lamp are

harmful to eyes and skin.

Always turn off UVC electrical supply before any maintenance.

To protect unit from flooding, leave a minimum 5cm showing above ground level to protect UVC electrics.

Never immerse unit in water.

Locate unit 1m minimum from pond edge to ensure the filter cannot fall in.

MAINTENANCE & CLEANING

Your Midipond filter has been designed to need

a minimum of maintenance.

When the filter system is first installed filter

cleaning may be increased for a period until

the back log of accumulated pond waste is

removed.

FILTER

CLEANING

MAINTENANCE & CLEANING

Routine maintenance

Hydroscreen chamber

When the hydroscreen chamber fills with water and overflows into the foam chamber, remove and wash

out under a tap. It is not necessary to remove the metal screen from its carrier for routine cleaning.

Graded foams

The filter foams only need cleaning when the foam chamber is full with water and the water layer above

the foams starts to significantly overflow the partition into the cartridge chamber.

25% of the pumps input may be allowed to overflow the partition into the cartridge chamber, prior to cleaning.

Cleaning the foams before the foam chamber overflows will result in decreased filter efficiency as the

foams work most effectively when partially blocked.

Foams may be cleaned vigorously under a running tap or hose.

Adding Interpet Bio Start after filter maintenance will help replenish these beneficial bacterial populations,

and is highly recommended during the first two months of operation when the filter is slowly being colonised.

Professional ceramic bio media

These will only need very occasional cleaning (once per year), but must be rinsed in pond water to

prevent damaging the beneficial bacteria which help maintain a healthy pond.

HOW IT WORKS - FLOW DETAIL

WOOL

CARTRIDGE

PARTITION

CARBON

CHAMBER

OVERFLOW

CARTRIDGE

OUTLET

CHAMBER

MAXIMUM

OUTLET

CHAMBER

WATER LEVEL

OUTLET

HOSES

HYDROSCREEN

CHAMBER

UVC

VENTURI

FOAM

CHAMBER

FOAM

COARSE

MEDIUM

FINE

CERAMIC

BIO MEDIA

AERATION

CHAMBER