ARNOLD MCU 400 D Manuel - Sayfa 12

Kontrolör ARNOLD MCU 400 D için çevrimiçi göz atın veya pdf Manuel indirin. ARNOLD MCU 400 D 20 sayfaları. Mirrorball motorcontroller

Mirrorball Motorcontroller

Control Panel

DMX Control Mode

The devices are individually addressed on a data-link and connected to the controller. The devices
respond to the DMX signal from the controller. (When you select the DMX address and save it, the
controller will display the saved DMX address the next time.)

DMX Addressing

The control panel on the front of the device allows you to assign the DMX fixture address, which is the first
channel from which the device will respond to the controller.
Please note when you use the controller, the device has 2 channels.
When using multiple Mirrorball Controllers make sure you set the DMX addresses right.
Therefore, the DMX address of the first Mirrorball Controller should be 1(001); the DMX address of the
second Mirrorball Controller should be 1+2=3 (003); the DMX address of the third Mirrorball Controller
should be 3+2=5 (005), etc. Please, be sure that you do not have any overlapping channels in order to
control each Mirrorball Controller correctly. If two or more Mirrorball Controllers are addressed similarly,
they will work similarly.
Controlling:
After having addressed all Mirrorball Controllers, you may now start operating these via your lighting
controller.
Note: After switching on, the Mirrorball Controller will automatically detect whether DMX 512 data is
received or not. The problem may be:
The XLR cable from the controller is not connected with the input of the Mirrorball Controller.
The controller is switched off or defective, the cable or connector is defective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Ordercode: 60455
A) OLED display
B)
UP button
C) DOWN button
D) SELECT button
Fig. 05
11